The Model TGB-96 Supervised Pattern Recognition Technology Glass Break Detector is a glass break detector with a built-in transmitter designed for use with Linear's SX Format receivers. When breaking glass is detected, the transmitter sends a digitally coded signal to its companion receiver/control.

Coding switches are not required or used in the T-90. Each transmitter is pre-coded at the factory to a unique code. With the SX format, there are more than sixteen million codes possible. The TGB-96 can send three different signals: alarm, low battery and status.

The unit is powered by two 3-volt lithium batteries. These batteries will last for approximately two and one half years under normal climatic conditions. If the battery voltage drops below a preset level, a low battery signal is sent with every alarm or test transmission.

General Specifications Dimensions: 4.25 in W x 3.13 in H x 1.70 in D (108 x 80 x 43 mm) Mounting: screws or double sided tape (supplied) Power: two 3V DL2450 lithium batteries (supplied) Battery Life: up to 3 years Operating Temperature: 32° to 122° F (0° - 50° C) Frequency: 303.875 MHz (North America) 433.92 MHz (international) Number of Codes: 16,777,216 Code Setting Method: factory programmed Glass Detection Range: 20 ft radius typical, 25 ft max Glass Detection Method: pattern recognition technology

Features Dual-technology detection device Full RF supervision Includes T-90D transmitter board Powered from one battery set Alarm, supervisory, and low battery transmissions Lithium battery powered Test, operate LED Shatter pro pattern recognition technology SX format