Model 9200 operators are designed to operate vehicular slide gates in limited (Class III) and restricted (Class IV) applications only. These operators should never be used in applications serving the general public. These operators are designed so that they can easily be mounted in the front, center or rear of the gate without any costly and time consuming field modifications. Center mounting the operator requires an optional pedestal mounting base.
Direct driven limit nuts.
Gate tracker reporting output.
Ports for plug-in loop detectors.
Two convenience outlets.
Fail-secure operation, includes crank for manual operation.
Built-in reset switch.
Built-in power On/Off switch.
SPECIFICATIONS Model 9200
Maximum gate length 100-feet.
Maximum gate weight 3000 pounds*.
(*Assumes gate is on level ground, in good condition with properly adjusted hardware. Other external factors may affect the performance of the gate operator.)
40:1 gear reduction running in a continuous oil bath.
1 HP continuous-duty motor.
Operator is shipped with chain brackets and 20-feet of #60 chain.
Class III and IV applications only.
Compliant with UL 325 and 991. ETL Listed.
(Note: To be compliant with UL 325 and industry safety guidelines, a secondary entrapment prevention device(s) is required to be installed with this gate operator. Your professional DKS system installer can provide you with more details on these devices and on current industry safety standards.)
Dimensions: 16"W x 34"H x 16"D
OPTIONS AVAILABLE WITH THIS OPERATOR
Heavy-duty pedestal mounting stand.
(Recommended for gates over 30-feet to allow use of a chain support rail).
Plug-in loop detectors.
Heater kit for cold environments.
High security industrial gate operator
This operator is designed for very large and heavy gates in limited and restricted access applications only and is not designed for applications serving the general public such as gated communities, apartment houses, residential applications or public parking areas or garages.
Adjustable partial open limit setting.
Inherent reverse system monitors both motor current and output shaft speed (RPMs) for batter reliability and performance.
Includes the advanced features as described under the 9100 models.
This is a high security operator that is designed for fail-safe operation. When a power outage occurs, the gate will remain locked and cannot be manually forced open.
Manual operation is by means of an inter-locked (motor cannot start while crank is inserted) manual hand crank that uses the operator drive system for easy operation of large heavy gates.
Maximum gate weight is 3000lbs, maximum gate length is 100ft